Three single LED outputs, 10mA each channel maximum current draw. 30mA total.
4 Modes - DC, DCC Locomotive, DCC Accessory, or DCC NMRA Signal mode.
15mm x 18mm / .60 x .70 inches
The Light-It is a multi-purpose programmable DCC lighting decoder that uses DCC track power and standard DCC lighting commands in four DCC modes. It can also be used in a basic DC mode. One Light-It contains three programmable lighting outputs with a complete array of lighting effects. Suitable for signal heads, passenger cars, locomotive lighting, cabooses, structure lighting, and many other uses.
Lighting decoder w/built-in white LED
Features of this decoder::
• Works on DCC or DC (limited operation on DC)
• Works with loco, accessory, or signal addressing using NMRA DCC commands for these modes
• Built-In Warm white LED (can be disabled)
• Up to 3 LEDs may be controlled separately
• Built-in resistors – just connect LEDs
• Functions as an NMRA Signal decoder with 18 aspects using NMRA DCC SIGNAL commands.
• Each output is individually dimmable
4 Modes - DC, DCC Locomotive, DCC Accessory, or DCC NMRA Signal mode.
• 15 Lighting EFX • 18 Signal Aspects
The total board output is 30mA. Three output channels with 10mA per output rated at 5v for single LEDs only.
5240161 Light It-3 A 3-pack of the Light-It Universal Lighting and Signal Decoder.
5240162 Light It-6 A 6-pack of the Light-It Universal Lighting and Signal Decoder.
5240163 Light It-15 A 15-pack of the Light-It Universal Lighting and Signal Decoder.
Comments