On some, but not all, DCC decoders you will get different behaviors when switching between locos depending on how you perform that task. Doing a "select loco" compared to using the "recall" button may have very different results. To avoid unexpected shutdowns when changing between locos use the recall button instead of using the select loco button.
If the recall button is not an option for you, try to resolve the decoder issue by enabling different features in the command station as below.
Our command stations have a function refresh option which is off by default but can be enabled if needed.
On the 2 amp Power Cab Starter set: press prog/esc 5 times to get to “set cmd station” Press enter 10 times to scroll through the command station options Look for “function refresh enable” Press 1 to enable.
On the 5 amp Powerhouse, Ph-Pro, Power Pro, or CS02: press prog/esc 5 times to get to “set cmd station” Press enter 17 times to scroll through the command station options Look for “function refresh enable” Press 1 to enable.
==========================================================
Comments