Switching to and from Program track mode on a PH-Pro

Note:  Only ONE side of the box is active at a time.

When you put the Ph-Pro system box into Program Track mode, the main track output on the left side that runs trains turns off. That means the red track power status light on the left side blinks. The right side of the box that runs the program track is now on. To exit program track mode, Press the PROG /ESC key until you return to the loco (LOC) screen or turn off your system. Reminder: You cannot RUN trains on the program track. As a best practice, I turn the system completely off when I am done programming a loco. Then, I move the loco back to the main track output for testing. Then, restore the power.  I often find that a loco will require a full reboot/power cycle for the new setting to take full effect.