IP Digital Point Motor

The following information was provided by Jim Hamilton at DCCconcepts Pty Ltd

Ensure the iP Digital motor is connected to the Track bus at terminals 1 and 2.  

1. The RUN/SET switch on the iP Digital motor needs to be set to SET.
2. Press SELECT ACCY on your handset.
3. Type in the accessory address you desire for that motor.
4. Press 1 or 2 (doesn't matter as nothing physical will happen).
5. Now move the RUN/SET switch on the motor back to RUN.

The motor should now operate on the address you selected.